Remove the four capscrews and housing.

Remove all gasket material from the cylinder block gasket surface.

NOTE: Do not cut the gasket mounting surface with the scraper.

Use solvent to clean the dipstick, dipstick tube, and the housing gasket surface.

Dry with compressed air.

Inspect the dipstick guide tube for cracks or other damage.

NOTE: If the guide tube is cracked, missing, or not angled downward in the oil pan, replace the dipstick tube housing.

Install the dipstick tube housing and a new gasket.

Install the four capscrews and tighten.

NOTE: Check the dipstick calibration. Refer to Procedure 007-009 in Section 7.